Kay Nichols - 06-May-10
- digger.kay@xtra.co.nz
- Dargaville
Replies - 1 -
Sigma MPC10 kiln controller
Instructions required
Can anyone out there help me. I am looking for instructions to reprogramme a Sigma MPC10 Kiln controller. Have searched everywhere and have come up blank. Bought this kiln second hand but with no instructions for controller, it already has 4 programmes on it but maximum fire is only 1015c which is too low for what I want. I am new to this pottery game so dont know where else to look. I am prepared to pay someone to reprogramme it for me if they know how. Hopefully someone can help. Many thanks Kay
Kristin Kay - 11-Aug-10
- kristinkay@slingshot.co.nz
- Whangarei
Hi there, I have a Sigma mpc10s controller so would be similar. I was just going to write how to do it but I think would be to complicated over email. Youre welcome to come to my house and I can show you how I use my controller. Email me back so we can make a time.
Cheers - Kristin
kristinkay@slingshot.co.nz
Disclaimer:
The opinions posted in the forum section of this website are not necessarily
the opinions of the New Zealand Society of Potters
